I have these 18x11 Apex and 315/40 Nitto Nt05s yet to mount square for all ponies. I’ll need some spacers and maybe camber. Also, have 275/35/18 square setup BF Goodrich Rivals on the stock Shelby wheels. Been using Nitto’s mostly in the past. I think I have enough trophies around so I’m just...

This is the Build Thread for Bad Boss. Reply below.

This is the Build Thread for 1st Shelby. Reply below.

This is the Build Thread for Ole Yeller. Reply below.

So my track build seems to sit a little high in the rear with MM high rate springs with 350# front coil overs. MM says lower rate would be to soft. What concerns me is the top six coils are fully compressed at rest. Angle seems odd too. MM says remove pads. I’m wondering if I can cut a coil off...

Todd and Terry in the GT

Not sure that video upload worked.

So I talked to the Ford guy driving the Mach e, it wasn’t Todd. He said he was only 3 seconds slower on the short autocross than driving his GT350. He thought with good tires and a third motor it would out do his car. Here’s a clip of the old Gt350s on track. They were from Colorado, appeared to...

All together now

A clip of group 1 with the cackling old Gt350s