I repaired jumper harness and tried to push stock exhaust as forward as I could to gain clearance, but have no doubt wires will rub again. Terrible design from Ford, as mentioned above. My plan is simple, start car, put in track mode, and pull exhaust fuse, leaving valve open (which isn't that...

Just had the exact same issue with Mach 1 at Pittrace, blown fuse, found cut wires at passenger side exhaust valve connector. Did dealer correct problem? What is the part number of the short harness?

I'm going, #61 GHIG

New in the box Stilo ST5 FN (SA2015) helmet, clear shield, bag, Size XL/61, PRICE $650 (includes shipping in conus) Also, Stilo dark red mirror visor, selling separately, PRICE $125 (includes shipping in conus)

Two (2) used NT01 tires for sale, 305/35ZR18, used one day at Watkins Glen HPDE event, excellent condition, PRICE $100 each plus shipping, located in Western New York.

Complete set of (4) Enkei PF01 high performance wheels with Nitto NT01 tires to fit 2010 - 2014 Ford Mustang, ran this set-up on 2013 Boss, front 18 x 9.5 (+35 mm offset) with 275/40ZR18 tires (half worn), rear 18 x 10.5 (+47 mm offset) with 305/35ZR18 tires (very good condition), includes metal...

Re: Pics of your Boss or Mustang at the track!!!Canadian Tire Motorsports Park aka Mosport

I'm in for both days and hoping for 80 degrees and sunny!

Re: Boss/ S197 specific 2015 Wall Calendar - High def pics needed **HELP!**New York State Safety Track

I couldn't resist the trade-in program, so I ordered up the new "Race Spec" to replace my 2014 MGW shifter, received unit in only a couple days, and swapped out yesterday. Install was easy (no car lift), and I too am very impressed with design and function of this baby. I thought the previous...

Workshop manual states to remove 2 plastic front pins along with 8 lower panel pins, final step is to use "suitable tool" and release 8 hidden pin-type retainers. On the 2013 Boss, who has removed the rocker panel moulding and where are these hidden retainers?

Re: Auto-Blip Install and Instruction InformationI installed the Auto-Blip before my last run at Watkins Glen. Worked perfect and definitely eliminates any thoughts of messing up rev match, heel/toe thing. Smoother downshifts seemed easier on the car, and really liked the ability to adjust...

Mike, looks like you're getting plenty of traction to me! And, since you passed the "green boss" with ease, the "green boss" has decided to study your lines more closely. I need to get down tighter to that apex. That was my first trackday with the Pagid 29/56 pads from Pete and I was very...

Where are you guys getting these hubcentric rings? I just purchased some Enkei PF01 rims and no rings were included. All I see online is the cheap plastic ones that likely would melt on a good track day. Also, what's the best valve stem to use on these rims? Enkei includes one, but it looks...

I believe Watson will now send these kits out with extra material along the sides. This material can be trimmed and fills in any gaps that can result from variations in our interior side panels. During installation of the rollbar, you're instructed to cut the inside panel foam, which depending...