- Thread starter
- #61
Built the diffusers for the splitter.
Bad news is that the coilovers which were to ship last week are still a unknown, vendor isn’t responding. So I’m going to miss the sept 3 race.
Only exciter wire to alternator and disable steering wheel lock left inside.
Rear diffuser, backing plates for brake ducts and side splitters left for fab.
Should have the plywood splitter in a layer of resin this weekend. I need to fiddle with the mounts as the bumper\splitter come off pretty easy, but its binding a bit on install.
Got the k-link and should get that installed this weekend now that I have the measurements for install from Kenny brown.
If my friend can fit me in, dyno time next week!
Bad news is that the coilovers which were to ship last week are still a unknown, vendor isn’t responding. So I’m going to miss the sept 3 race.
Only exciter wire to alternator and disable steering wheel lock left inside.
Rear diffuser, backing plates for brake ducts and side splitters left for fab.
Should have the plywood splitter in a layer of resin this weekend. I need to fiddle with the mounts as the bumper\splitter come off pretty easy, but its binding a bit on install.
Got the k-link and should get that installed this weekend now that I have the measurements for install from Kenny brown.
If my friend can fit me in, dyno time next week!
Last edited: